We usually refer to the 7075 aluminum plate, which is mainly an alloy aluminum plate made of zinc and aluminum. The secondary material has a small amount of magnesium and copper. Our super-hard aluminum alloy is made of lead, magnesium and copper alloy. It is very close to the hardness of steel, so it can be used for heat treatment, and it has strong corrosion resistance and strong mechanical properties.
Of course, the 7075 is a good material for customers who choose it. Because it is a cold-treated forging alloy, it has higher strength and is stronger than soft steel, so it has become one of the strong alloys that many merchants like. Then a big feature of the 7075 aluminum plate is that the fine grain can make the deep drilling performance better, and it can enhance the wear resistance of the tool and make the thread rolling more special.
As far as the use of our 7075 aluminum plate is concerned, there are many things that can be said. The typical use of the 7075 is for aviation. When we manufacture airplanes, the structure of the aircraft usually requires very high aluminum sheets, must be strong, and has high corrosion resistance. Because on the plane, due to the pressure on the ground and in the air, high requirements are necessary, because the safety of the personnel on board must be guaranteed. The 7075 aluminum plate just meets this requirement. After solution treatment, its properties are very good, and the effect of heat treatment strengthening is also very small, and it has high strength below 150 °C, and it also has good strength at low temperatures.
Therefore, many large companies will take advantage of these advantages of the 7075 aluminum plate to meet all aspects of their needs. It is also a good choice. Of course, when purchasing, we must also pay attention to the quality of some manufacturers, and some large manufacturers have relatively high quality.