What are the precautions in the daily maintenance of aluminum alloy anodizing solution?
專欄:Industry information
發布日期:2014-12-15
閱讀量:509
作者:佚名
收藏:
The alkali-etched aluminum alloy workpiece must be protected from oil stains before being clamped, and the cleaned workpiece is prevented from being contaminated by oil to affect the nor..........

        The alkali-etched aluminum alloy workpiece must be protected from oil stains before being clamped, and the cleaned workpiece is prevented from being contaminated by oil to affect the normal growth of the film.

        After the aluminum alloy workpiece is pretreated, it should be anodized immediately to avoid the formation of natural oxide film and affect the quality failure of the flower.

        If the surface of the anodizing solution is oily or other floating objects should be removed in time to avoid quality failure such as film fading.

The bath should be analyzed periodically. Generally, only the concentration of free sulfuric acid will gradually decrease, while the aluminum content will increase. When the free sulfuric acid concentration is reduced to the limit concentration and the aluminum content has not yet risen to the upper limit, only sulfuric acid is metered in. When the aluminum alloy content exceeds the specified upper limit, discharge 1/4-1/3 of the tank night, then add sulfuric acid and deionized water.

        There is less sediment in the oxidation tank. Generally, it only takes one year to clean the guide tank thoroughly. At this time, the cathode plate should be brushed or replaced.

        The cathode plate should be kept clean and well conducted.

        Strictly observe the requirements of volume current density and anodizing area and tank area ratio.

上一頁:How to judge the corrosion of aluminum alloy 7075/6061? What is the corrosion product?
下一頁:Aluminum-magnesium alloy and product quality supervision and inspection center officially put into u
湖北11选5-首页