ACP5080

  • ACP5080
  • ACP5080
  • ACP5080
ACP5080
  • 產品介紹

Chemical Composition

EN AW-5083 (AlMg4.5Mn0.7), acc. to DIN EN 573-3 / 3.3547


Material Properties

Machinability very good (HSC/HPS excellent)

Weldability (TIG, MIG) good (with S Al 5183)

Anodising Properties good, not decorative

Polishing very good

Corrosion Resistance very good

Eroding Properties good


Typical Mechanical Properties

Tensile Strength R m 240-290 MPa (N/mm 2 )

0.2 % Yield Strength R p 0.2 110-130 MPa (N/mm 2 )

Elongation A 5 % 15

Brinell Hardness HB 70


Typical Physical Properties

Density 2.66 g/cm 3

Thermal Conductivity 110-140 W/(mK)

Electrical Conductivity 16-19 MS/m (m/Ω mm 2 )

Modulus of Elasticity ~70,000 N/mm 2

Coefficient of Thermal

Expansion 24.2* 10 -6 /K


Thickness Range & Sizes

Thickness between 8 and 1050 mm. Plates and pre-cut sizes in every

dimension depending on the block formats.

Thickness* max.Width* Length*

560 mm x 1320 mm x 3020 mm (up to 6000 mm)

560 mm x 1520 mm x 3020 mm (up to 6000 mm)

560 mm x 1570 mm x 3670 mm (up to 6000 mm)

560 mm x 2160 mm x 4000 mm (up to 6000 mm)

800 mm x 1570 mm x 4000 mm

1050 mm x 1700 mm x 3000 mm (up to 4000 mm)

(Blanks, rings and pre-cut sizes on request.)

> 2160 mm Width: Please see the product information for

ACP 5080 GIANT / ACP 5080R GIANT


Tolerances

Surface sawn on all sides

Tolerance in Thickness 0/+3 mm (closer on request)

Tolerance in Width for Plates 0/+10 mm

Tolerance in Length for Plates 0/+15 mm

Tolerance (L/W) for Sized Cuts 0/+3 mm (closer on request)

上一頁
下一頁
湖北11选5-首页